Rugby: create

Groups of 4 and two groups of defenders with contact pads. 1 ball per group. The ball carrier drives into the contact pads and presents ball backwards. Player 2 binds on, face to face and secures ball, player 3 binds on the other side to form a front row. All attackers bind together and drive defenders back 2-3 metres. Player 4 takes ball out at back and runs back around cone with players 1-3 in support. Repeat going back the other way until all attackers have practised each role.

In fours players are moving up a channel. The support runner (blue player in the animation) calls themselves into the line, receives a pass, offloads and repeats down the second channel. Ideally you would like your players to form a diamond: a ball carrier, support running left, support running right, and a support runner behind who can come onto the ball at any angle. When the first group leaves the first channel, the second group should begin. That way there will always be activity. Players should change their positions in the diamond.

Tell your players the following: Using just one hand they should pass the ball to each other, spinning the ball. They will continue down the grid until reaching the end before turning back and doing the same with the opposite passing hand. They can use two hands to catch. They should be jogging. That's it, get working. Refer to the coaching points in order to help your players improve. This drill is about helping players understand and develop their spin pass, while improving the quality of their pass. It should be using in conjunction with other training exercises to develop the spin pass.

Tell your players the following...... The ball carrier (A) runs straight in a line and makes a normal lateral pass to the supporting player (B) After passing the ball A runs towards and behind B After B catches the pass they angle their run towards the direction the pass has come from and so create space A runs around B and straightens as they receive the pass In effect you want the players to loop around the new ball carrier after they make their pass.

Using just one hand they should pass the ball to each other. The pass should come from on, or behind the hip. They should make 10 passes on one hand, and then 10 passes on the opposite hand. That's it, lets get going - it's a race.  Any dropped balls - and your group has to start again. That's it, get working.

Tell your players the following...... The ball carrier will run/carry the ball directly across the grid, offloading it to the player opposite. The offload will be different, depending on the coaches call - so you need to listen. There will be traffic in the center of the grid, so avoid it. Ok - lets get moving, the first call is to pop to the receiver - the pop should be legal! Calls include: POP THE BALL, ROLL THE BALL, SET IT DOWN, THROW IT UP, GUT PASS (not too hard).

With each new instruction to players you'll be having a race, lets see which group is the fastest - no cheating! Don't spend too much time talking, get the players into their groups quickly and tell them to do the following: Pass the ball between your legs to the person behind you - keep going until the ball reaches the end of the line. Same thing as above, but this time when the ball reaches the end of the line, the player at the end runs the ball back and the ball starts the same journey again. This is repeating until the every player has run from the back to the front of the line. Same idea but this time under legs then next person passes over head, next under legs (under/over/under etc.) Same idea but twist hips to pass to person behind first to the left then to the right - back person runs to front. As above but just over the head. Progress this with your own ideas e.g. pass to the person behind you with one hand etc. This warm-up should be full of fun.

Tell your players the following... On GO Player A passes to B who in turn passes to Player C. At the same time Player E passes F. Once the players have passed the ball they then swap with the opposite player. Player A swaps with Player E, player B swaps with Player F, Player C with Player G, Player D with H. It's important that players only swap once they have passed the ball and only pass it when a player is in position to receive it. So - players swap following a pass - with their opposite number, the pass is always left.

Tell them the following...... Each attack will be up and down, up the left and down the right side of the cones. Eack attack will see the ball move down the line once. Run out to far cone and back - 1/2 pace - no forward passes. Run out to third cone and back - jog - 3/4 pace back. Run out to second cone and back - fast out - fast back. Off-load the ball to the next attacking line - they do the same. That's it, get working. Refer to the coaching points in order to help your players improve.

This drill is designed to work on the loop; on of the simplest and most effective ways to create your own overlap/space out wide Start with three attackers and three defenders using tackle bags in front of them.Attacker 1 passes to attacker 2 and begins to loop around.Player 1 should then receive the ball back and his next aim is to fix the third defender.Attacker three should make his way out to the edge where the space has been created.Attacker 1 then passes to attacker 3 who has space to get around the defence. Using this drill will develop your players handling under pressure and their attacking vision and ability to create space

Four players per group inside a 10m x 30m Channel. Requires 10 cones and 1 ball. Two players start outside of the grid with two players inside. One of the outside players passes the ball to one of the inside players before both of the outside players (defenders) run through the red gates. The two inside players (attackers) have to try and cross the try line before the defenders can tackle them, if the attackers are too slow they will create a two 2 v 1 situation.

This is a simple 2 v 1. The two players have to get past the one defender without being touched, that's it. The defender will start 10 meters back, and can move anywhere inside the box. The attack must remain inside the box and all pass msut be legal. Don't forget to change the defender.

This drill coaches players the lines they should run when receiving the ball in order to maximise the chance of them breaking the gain line.<li dir=&quot;ltr&quot;>Use a tackle bag to simulate where the ruck and offside line would be.<li dir=&quot;ltr&quot;>The players line up as if they were going to come &quot;around the corner&quot; to receive the ball.<li dir=&quot;ltr&quot;>Players should run an L shaped running line to get across the first defender and then footwork to get through the second defender.Progression (0.49) - Add an extra pass to the drill<li dir=&quot;ltr&quot;>For the first receiver the drill is exactly the same in terms of the running line.<li dir=&quot;ltr&quot;>Then there is a second player on his outside shoulder who uses the same running line to beat the second defender.<li dir=&quot;ltr&quot;>The first receiver has a choice (1.19) - whether to go through the gain line and pass or pass before he gets to the gainline.What is the gain line?The gain line is an imaginary line in rugby parallel to the halfway line that is the back foot of the breakdown or the defences offsideline.

A drill to practice decision making and finding space between defenders.Set up a line of three defenders with tackle shields (roughly 2m apart), with one defender 2/3m behind the middle defender (blue - see diagram).Roughly 5m opposite the defenders set up three attackers, one opposite the middle defender with the ball and one either side of the ball carrier (red - see diagram).When the ball carrier starts running towards the defenders the defender behind moves in to fill one of the defensive gaps. The attackers must successfully select the space and pass the ball to the player to run through the gap and score. PROGRESSION:Defenders put more pressure on attackers.All players must touch the ball. The third attacker must get through their space as a support player.The ball starts on one side instead of in the middle and players have to call whether the space is the first gap or the second gap, in which case the ball carrier should through a miss-pass.

<span style=&quot;background-color: transparent;&quot;>Set up: the cones as shown with a cone 10 meters each side of the posts on the try line. This will mark where the ball will be passed from (feeder) preferably from a scrum half.<span style=&quot;background-color: transparent;&quot;>Divide the group into 3 and ask them to stand in single file behind each cone.<span style=&quot;background-color: transparent;&quot;>The ball is fed from a position alternately from either side of the post. This will encourage the players to scan, communicate and to be expectant of the ball.<span style=&quot;background-color: transparent;&quot;>The players on the cones opposite the posts will either be the 1st receiver or the BANG option runner. The BANG runner is always running an out to in, or up to in line to fix the 2nd defender.<span style=&quot;background-color: transparent;&quot;>The players on the middle cone will receive the ball in the BINGO (pull back) option outside the ‘outside’ post or just in behind the BANG player.<span style=&quot;background-color: transparent;&quot;>The BINGO players should run and an arced run to receive the ball outside the outer post. The BINGO player should try to straighten up prior to receiving or on receiving the ball.<br>Progression:<span style=&quot;background-color: transparent;&quot;>Get 2 players or coaches to stand in front of the posts with 2 different coloured cones in their hands on their hips.<span style=&quot;background-color: transparent;&quot;>The cones will represent the ‘hips’ of the 2nd defender.<span style=&quot;background-color: transparent;&quot;>The aim is to encourage the 1st receiver to scan, look, and make a quick decision (choice of pass) depending on what the defender is doing.<span style=&quot;background-color: transparent;&quot;>If the 1st receivers sees the ‘inside’ cone on the 2nd defender then they must assume the defenders hips are turned OUT and make a short pass to the BANG runner.<span style=&quot;background-color: transparent;&quot;>If the 1st receivers sees the ‘outside’ cone on the 2nd defender then they must assume the defenders hips are turned IN and make a PULL BACK pass to the BINGO runner.

The players stood behind the line work the ball up through the channel in groups of 5. As they progress up the area they work the ball left and right. Defenders are placed on cones which have been given a number. As the group work their way up the channel the coach could call <em>1</em>. At this point one player from cone <em>1</em> runs out to defend. If a call of <em>1</em>, <em>2</em> is made then one player from cone <em>1</em> and <em>2</em> come out to defend. A call of <em>2</em>,<em>2</em> means two players from cone 2 come out to defend and so on... The diagram shows a call of <em>4, 1.</em>

Groups of 4 and two groups of defenders with contact pads. 1 ball per group. The ball carrier drives into the contact pads and presents ball backwards. Player 2 binds on, face to face and secures ball, player 3 binds on the other side to form a front row. All attackers bind together and drive defenders back 2-3 metres. Player 4 takes ball out at back and runs back around cone with players 1-3 in support. Repeat going back the other way until all attackers have practised each role.

On GO, the group moves towards the cone, pop passing between all players in close proximity. The defender drifts across. At the cone, the players spread out and attack the line at pace, angling their runs right as they come on to the ball. Drawing the defender, creating space outside.

This passing exercise will keep large groups of players busy passing, running onto, and moving the ball in traffic without the need to spend large amounts of time standing around and doing very little. It's a little confusing to start with, but when the players get going - it's great fun and very busy. Create a large box, the size is up to you and can be varied depending on your coaching goals. Each side of the box should have 4/5 players, more or less if you wish, standing in an attacking passing line - ready to go. You'll need two balls, give one ball to the first player on one of the lines, and the other to the last player on the line opposite. The lines advance passing the ball down the line as they go - they will pass through one another. When the ball gets to the end of the line, the last ball holder passes the ball to the first receiver of the line closest to them - and that line advances. There should be two lines active at any one time, and two lines getting ready to go. I hope that makes sense!